Daikin FXDQ07MVJU Operation Manual page 5

• Do not wash the air conditioner with water.
Doing so may result in an electric shock.
• Consult with installation contractor for cleaning the inside
of the air conditioner.
Wrong cleaning may make the plastics parts broken or cause
failure of water leakage or electric shock.
• Use a stable stool.
Use extra cautions when cleaning the air conditioner.
〈Maintenance and inspection〉
• Clean the drain pan periodically. The drain pipes clogged
with dust will cause water leakage.
• For cleaning, consult with your Daikin dealer.
(Before each season when cooling or heating is required,
clean the air conditioner.)
• If the area around the indoor unit is very dusty, use a dust-
proof cover (local procurement).
〈Cleaning the inside of the indoor unit〉
• It is necessary to clean the inside of the indoor unit periodi-
cally.
Since the cleaning requires special technologies, request a
Daikin dealer to clean them.
Daily maintenance:
〈Cleaning the air filter〉
Explanation
• Removing the air filter except when cleaning the air condi-
tioner may result in accidents.
• When the mark is displayed on the remote controller,
please clean the filter.
• When the operating time exceeds the designated time, this
mark will be displayed.
• If using the air conditioner under very dusty environment,
increase the frequency of air filter cleaning.
• When you want to change the setting time until the
mark is displayed, consult with your dealer.
(The default factory setting is 2500 hours.)
• There are the following time, display pattern.
1250, 2500, 5000, 10000
1. Remove the air filter.
Main unit
Filter
Force
In case of bottom side
2. Clean it.
CAUTION
• Do not wash the air conditioner with hot water of more than
120°F. Doing so may result in discoloration or deformation.
• Never dry the filter by direct firing. Doing so may
result in burning.
• For cleaning local procurements, consult with your
dealer.
(1) Use a vacuum cleaner (A) or wash the air filter (B) to remove
dust and trash.
(A) Remove dust and trash using a vacuum cleaner.
(B) Wash it with water.
When the air filter is very dirty, use a soft brush and neutral
detergent.
↓
Dewater and dry in the shade.
3. Attach the air filter.
4. Push the "filter sign reset" button on the remote controller.
The display " " vanishes.
〈Cleaning the air outlet and exterior〉
CAUTION
• Do not use gasoline, benzene, thinner, polishing powder or
liquid insecticide.
Do not use hot water of 120°F or higher, as doing so may
result in discoloration or deformation.
Attach the filter to the
Force
main unit while pushing
down on the tabs.
In case of back side
4