Installation Instructions For Stacking; Self Diagnostics Failure Code - Panasonic NE-2156 Operating Instructions Manual

Installation Instructions for Stacking

IMPORTANT
1. Disconnect or unplug all units from the wall socket
before attempting to stack.
2. For stacking installation, you must use the
PANASONIC Joining Plate which is enclosed with
this unit.
INSTALLATION
1. Stack the units and remove five screws (a) as shown in Fig.1.
2. Loosen the screw (b).
3. Projection on Joining Plate must face away from the oven. Place Joining Plate on the screw (b).
4. Attach and tighten five screws (a) and the screw (b). See Fig.2.
5. Ensure the top oven is at a safe and workable height.
(b)
Fig. 1
Self Diagnostics Failure Code Explanation
This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs.
What to do when a Failure Code appears: Disconnect the oven from the electricity supply and wait more than
ten seconds before reconnecting. If normal operation does not resume, follow the next chart.
CODE PROBLEM
F01 Too high temperature of
exhausted air
F33-34 Defective thermistor circuit
F05 Defective memory IC
F81-82 Defective relay circuit
F86-87 Defective relay circuit
F44 Defective control panel
Note: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.
3. The following PANASONIC models only are suitable
for stacking:
NE-1057, NE-1457, NE-1247, NE-1747, NE-1047,
NE-1447, NE-1257, NE-1757, NE-1442, NE-1856,
NE-1456, NE-1846, NE-1446, NE-2156, NE-2146
4. The maximum stacking height is the total heights of
two units.
PREPARATION
Be sure the oven cavity is empty.
Joining Plate
Joining Plate
Projection
(a)
The oven shuts off automatically. Disconnect the appliance from the electricity
supply. The oven beeps continuously and resets for operation when cool. Move
the oven to a cooler location. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. If the problem occurs during memory
heating, press Stop/Reset pad. Then other memory program and manual heating
will be possible.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. Press Stop/Reset pad and try again.
The oven shuts off automatically. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
- 17 -
Projection
Fig. 2
WHAT TO DO