Care And Maintenance - Arctic King rev11/45 Owner's Manual

CARE AND MAINTENANCE
Removing The Coiiec:ted Water
There are two ways to remove collected water.
1. Use The Bucket
® When the bucket is full, the unit will automatically stop
running, and the Furl indicator Uightwifl flash.
® Slowly pull out the bucket. Hold left and right handles
securely, and carefully puff out straight so water will
not spill. Do not put the tank on the floor because the
bottom of the bucket is not flat. Otherwise the bucket
will fail and cause the water to spill.
® Pour the water and replace the bucket.The bucket
must be in place and securely seated for the
dehumidifier to operate.
® The unit wHI restart when the bucket is replaced
in proper position.
NOTE:
® When you remove the bucket, do not touch any parts
inside the unit. Doing so may damage the product.
® Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
2. Continuous Draining
Water can be automatically emptied into a floor
drain by attaching the unit with a drain hose.
® Removethe water bucketfrom the front of the unit, you will
find a sectionof hose locatedabove the bucket.
® Removethe rubber plug from the back of the unit(see Fig.8).
® insert the drain hose throughthe hole in the back of the unit
and securelypress it onto the connectoron the front of the
unit(see Fig.9). Then lead the drain hose to the floor drain or
a suitable drainage facility.
® Replacethe bucketin the unit. The bucket must be in place
and securelyseated.
1. Putl out the bucket a little.
Fig.5
2. Hold both sides of the bucket
securely, and putl it out from
the unit.
Fig.6
3. Pour the water out.
Jf
Fig.7
into the drain
hole
NOTE: When the continuous drain feature is not being
used, remove the drain hose from the connector and
attach the back drain hole with the rubber plug.
Fig.8
rain hose
Coooector
Fig,9