Advertisement
Mounting
Diameter
11.25"
286mm
Mounting
Depth
7.9"
200mm
Overall
Depth
9"
SUGGESTED ENCLOSURE PARAMETERS
230 mm
SEALED
ENCLOSURE
ENCLOSURE DIM.
INCHES (MM)
F-3 (Hz)
VENTED
ENCLOSURE
ENCLOSURE DIM.
INCHES (MM)
SLOT PORT
(H X W X L)
INCHES (MM)
SYSTEM
GAIN (+dB/Hz)
F-3 (Hz)
TUNING
FREQUENCY (Hz)
NOTE: All volumes are based on 3/4" wood.
ENCLOSURE DESIGN NOTES AND CONSIDERATIONS
The enclosure dimensions provided may be adjusted to suit your vehicle layout, but follow our guidelines for enclosure VOLUME. For example, if
the suggestions dimensions for an enclosure are 12"W x 16" H x 14" D, multiplying these dimensions together will yield the volume in cubic inches,
which can then be divided by 1728 to yield the volume in cubic feet. If your vehicle cannot accommodate the 16" height but a 12" will fit, add the 4"
difference to the width or the depth. Check your math to see if the new dimensions multiply out to the same volume.
If the port length recommended is too long to fit into your enclosure, you can bend the port in order to attain the desired length.
The suggested SLOT port sizes are based on the enclosure height, allowing you to add the port by simply reducing the size of the front panel of the
enclosure by the width of the port and adding in a single piece of wood top-to-bottom in the enclosure, starting at the front panel and continuing
toward the back by recommended slot depth.
For SLOT ports, you can adjust the H and W dimensions as long as the cross-sectional area of the opening remains the same. For example, if the
recommended port cross section is 1.5" x 12.2", you can change this to (for example) 3.0" x 6.1" or 4.5" x 3.05". In all these cases, the cross-sectional
area of the port is 18.3 square inches.
PHYSICAL & INSTALLATION
PARAMETERS
VOICE COIL
WEIGHT
CONE
SURROUND
SPIDER
Overall
DUSTCAP
Diameter
12.9"
FRAME
328mm
TERMINALS
All specifications subject to change without notice.
SIZE, CUBIC FT (LITERS)
1.7 (50)
16 x 16 x 16
406 x 406 x 406
49.7549
46.1
SIZE, CUBIC FT (LITERS)
2.5 (70.8)
20 x 15.75 x 18
(505 x 401 x 457)
18.5 x 1.5 x 16.6
(470 x 38 x 422)
3.6/37
3.0" 4-Layer
33 lbs. Structure
Fiber Reinforced Paper
3-Layer Foam
Linear Progressive
Injection Molded
Cast Aluminum
10 Gauge Wire
29.5
35
ZRS12-1000
SPECIFICATIONS
PERFORMANCE
PARAMETERS
POWER
(WATTS RMS)
POWER
(WATTS PEAK)
NOM. IMPEDANCE
RE (OHMS)
FS (HZ)
QMS
QES
QTS
X-MAX
(MM)
VAS
(CU. FT.)
EFFICIENCY (SPL)
1000
2000
4
2
3.2
1.9
32.1
28.7
4.211
4.524
.512
.493
.444
.456
14.5
13
22.9
25.1
87.8
88.5
Advertisement
