Buick 2014 Regal Owner's Manual page 325

3. Press then scroll
until Jump Start displays.
4. Press to activate the jump
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and the
display will show WAIT TO
START.
6. When the jump start is complete,
the display will show ATTEMPT
START or JUMP START
DISABLED.
With the brake pedal not applied,
press and hold the ENGINE START/
STOP button for more than
five seconds. This will place the
vehicle in the Service Only Mode.
Proceed as follows:
1. Press then scroll
until the Settings menu displays.
2. Press to enter the
Settings menu.
or 3. Press
until Jump Start displays.
4. Press
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and the
display will show WAIT TO
START.
6. When the jump start is complete,
the display will show ATTEMPT
START or JUMP START
DISABLED.
If the vehicle is started, the
on-board jump start function will be
automatically disabled. If the vehicle
cranks but does not start, the
procedure may be repeated again.
If the vehicle start is still
unsuccessful, the jump start can be
attempted using the following jump
starting procedure under Jump
or
Starting (with or without eAssist).
then scroll or
to activate the jump
On-board jump starting may be
unavailable due to the 12-volt
battery charge level, the eAssist
battery charge level, power
capability, or an issue with the
eAssist system. In these cases, the
display will not be available because
of the power issue, or the DIC will
display JUMP START DISABLED
SEE OWNERS MANUAL.
For more information about the
vehicle battery, see
.
If the battery has run down, try to
use another vehicle and some
jumper cables to start the vehicle.
Be sure to use the following steps to
do it safely.