Advertisement
Quick Links
Advertisement
Related Manuals for NewAir AD-250
Summary of Contents for NewAir AD-250
- Page 1 OWNER'S MANUAL NEWAIR AD-250 DEHUMIDIFIER Please read and save these instructions...
- Page 2 TABLE OF CONTENTS _i!!_ii!i!U!_i'_!_L_i_E_i_!i_ii_iii!i61_ii!_!i ¸i_!_!N_ii_i_!_!!_!_i!_!i!!!i!_!i!!i_!!_!!_i!!_!!_!_!!_!i_...
- Page 3 Please read this owner's manual carefully and be sure to follow these safety instructions before using your dehumidifier for the first time. Always operate the dehumidifier in an upright position and place it on a flat, level surface. Do not submerge the unit under water or place it near other liquids.
- Page 4 Minimum Clearance Be sure to operate the dehumidifier in an upright position and place it on a flat, level surface. Maintain a minimum clearance of at least 20 inches (50 cm) away from other objects appliances (see diagram below)....
- Page 5 List of Parts 1. Control Knob Power Indicator Light Full Tank Indicator Light 4. Air Vents Water Tank Water Level Indicator Rubber Feet 9. Air Filter 10, Rear Panel 11. Power Cord...
- Page 6 Additional Included Accessories FI_ dlplor 8 ,noxtm cu_in_s - o:_llr,uom Spring for continuous drainage pipe Clip for continuous drainage pipe...
- Page 7 Placement The NewAir AD-250 dehumidifier can be used in a variety of settings such as bedrooms, living rooms, kitchens, and offices. Do not use this unit in bathrooms. Turninq the Dehumidifier On and Off The knob on the control panel is used to power the dehumidifier.
- Page 8 Continuous Drainaqe This dehumidifier also features a continuous drainage port. To continuously drain the unit, follow these steps: Pull out the rubber water stopper located on the bottom of the unit.
- Page 9 2. Removethe water tank from the unit and insertthe rubberstopperinto the continuous drainageport. 1. Pressthe two endsof clip as the way of arrowheadto enlargeit, 2. insertthe drainagepipe into the clip beforeconnectingto the drainageport. 3. clip it firmly at the connectionof drainage pipe &...
- Page 10 3. Insert the included spring into one end ofa PVC hose with an inner diameter of 10 mm and thickness of 1.5 mm (not included). Connect the hose (the side with the spring) to the drainage port and position other side to where you want the water to drain.
- Page 11 Note: To prevent electrical shock, turn off the unit and unplug it before performing maintenance or repairs. Re,qular Maintenance • Unplug the unit from the power supply if it will not be in use for an extended period of time. •...
- Page 12 • Clean the air filter at least once every two weeks with warm water (lower than 104°F or 40°C). Do not use chemical solvents or hot water to clean the air filter. • After cleaning the filter, let it air dry and keep it away from any heat sources. If any of these problems occur, please...