Engine Oil - Yamaha YFM80GX Owner's Manual

and its mating surface, and then wipe off any
grime from the spark plug threads.
1
3. Install the spark plug with the spark plug
wrench, and then tighten it to the specified
2
torque.
3
Tightening torque:
Spark plug:
4
12.5 Nm (1.3 m·kgf, 9.0 ft·lbf)
5
NOTE:
If a torque wrench is not available when installing
6
a spark plug, a good estimate of the correct torque
is 1/4–1/2 turn past finger tight. However, the spark
7
plug should be tightened to the specified torque as
soon as possible.
8
4. Install the spark plug cap.
9
EBU23253

Engine oil

10
The engine oil level should be checked before
11
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.
NOTE:
If the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least ten minutes until the oil set-
tles for an accurate reading.
3. Remove the engine oil filler cap, and then
wipe the dipstick off with a clean rag.
1
1. Dipstick
4. Insert the dipstick into the filler hole (without
screwing it in), and then remove it again to
check the oil level.
8-10