GE 49-90321 Installation Instructions Manual page 27

Installation instructions
_-I LEVEL THE WASHER OR DRYER
[]
[]
[]
Locate the 4 legs from the parts package
and install.
Stand the washer or dryer upright. Move
it close to its final location.
Make sure that the washer or dryer
is level by placing a spirit level on top.
Check side to side and front to back.
[] Use an open
ended wrench /
to adjust the
legs in and
out. Tighten
the lock nut
against the
bottom of
the pedestal.
NOTE: To minimize vibration, the locking
nuts must be tight.
[] REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side
of the unit.
[] FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation
Instructions to complete the installation.
[]
REINSTALL THE DRAWER
Check to
be sure the
slides are
closed.
[] Slide the
drawer
into the
Drawer
divider
opening.
Align the
drawer
supports to
the slides on
each side.
[] Reinstall the original screws into each
drawer slide. Tighten both screws.
[] Open the drawer fully. Slide drawer
divider into slots in the center of the
drawer. The drawer should slide
smoothly when you push it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE