SERVICE ADJUSTMENTS
Receive 60HZ cross hatch pattern. Press PIC. MODE key to set picture in STANDARD mode.
Adjust VSLOPE to obtain half of the crosshatch. Adjust VSCOR to obtain picture s best vertical
pin cushion. Adjust VSHIFT to obtain picture s vertical center at the center of CRT
mode.
Adjust HSHIFT to obtain picture s horizontal center at the center of CRT
Receive 60HZ monoscope pattern.Press PIC. MODE key to set picture in STANDARD mode.
Adjust VAMP to obtain picture s vertical redisplay ratio more than 90% in factory mode.
Vertical slope 60Hz
Vertical shift 60Hz
Vertical amplitude 60Hz
S-correction 60Hz
Horizontal shift 60Hz
OSD Position Adjustment
Menu OSD position adjustment: Receive 50/60HZ cross hatch pattern. Press PIC.MODE
key to set picture in STANDARD mode .
And OSD HPOS item to obtain menu OSD at the center of CRT screen.
White Balance Adjustment (Applied in factory)(KEY 9 )
Normally, this TV can auto adjust white balance, but for some CRT maybe need to adjust white
balance manually. Set BRIGHTNESS and CONTRAST at normal status , receive
enter factory mode. Press
RF.AGC Adjustment(KEY 7 )
Receive 60dB RF signal. Connect Digital voltmeter positive terminal to tuner AGC terminal
and negative terminal to GND.
Enter the AGC item in factory mode by the REMOTE CONTROL.
Method: Press key
and select
KEY 7
Adjust
+
on screen.
Press RECALL key to exit factory mode.
Item
and set BD at 31.Adjust RD and GD to obtain white balance.
KEY 9
SOUND MODE
RECALL
,
AGC item by
RF
P+
keys to obtain 2.8V digital voltage meter reading or till no NOISE
and
-18-
Display String
VSLOPE
VSHIFT
VAMP
VSCOR
HSHIFT
Press KEY 5 infactory mode, adjust OSD VPOS
CH I/II
to enter factory mode, then press
,
and
P -
.
screen in factory
screen in factory mode.
GREY SCALE and