Download Print this page

Lanier Color Developer – Cyan 480-0077 Material Safety Data Sheet page 2

Color developer-cyan for lanier lp036c

Advertisement

3
Page 2 of
CP-736
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the
Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or
personal injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Special Handling:
Cleanse skin after contact before breaks or meals, and end of workday.
Do not handle in areas where the wind blows.
Minimize the breathing of dust.
Special Storage:
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use.
Eye Protection: none required under normal use.
CHARACTERISTICS:
Appearance:
Cyan
Form:
Powder
Odor:
Slight plastic odor
Solubility in Water:
Insoluble
Specific gravity:
N/a
Density:
1.2 g/cm
Conditions to avoid: none
Hazardous decomposition products: will not occur
Ames test negative
Acute oral toxicity: 5000mg/kg (rat)
Special effects: Carcinogenicity: No data is available on this product.
Acute toxicity to fish: not available Bioaccumulation: Not known in bioaccumulation
Persistence/Degradability: Not known
Algae inhibition test: Not available
Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations.
Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper
method for disposal. Do not incinerate loos e or spilled developer.
International regulations:
RID/ADR Not applicable
DOT 49 CFR
Not applicable
ADNR
Not applicable
Specific precautionary transport measures: Avoid direct sunlight. Do not keep over 35 C (95 F).
Specific material to avoid:
MATERIAL SAFETY DATA SHEET
Section 6: Accidental Release Measures
Section 7: Handling and Storage
Section 9: Physical and Chemical Properties
3
Section 10: Stability and Reactivity
Materials to avoid: none
Section 11: Toxicological Information:
Acute skin irritation: Non-irritant
Acute allergenic effects: non-skin sensitive
Section 12: Environmental / Ecological Information
Acute toxicity to daphnia: Not available
Section 13: Disposal Consideration
Section 14: Transportation Information
ICAO-TI/ATA-DGR
UN Classification Number
IMDG Code
None in normal use.
Hand Protection: none required under normal use.
Skin Protection: none required under normal use.
Melting point:
Vapor pressure:
Vapor density:
Evaporation rate:
Boiling point:
Stability: Stable
Not applicable
Not applicable
Not applicable
N/a
N/a
N/a
N/a
N/a

Advertisement

loading

This manual is also suitable for:

480-0077