Cisco 10000 Series Product Bulletin page 6

Figure 4
L2TP Tunneled Architecture
Subscriber
The Cisco 10000 Series operates as a highly scalable LAC with a comprehensive set of PPP, AAA/RADIUS, and L2TP
attributes. In many cases, an ISP will contract the service provider to dictate the service rate for the subscriber. This
is usually implemented by ATM traffic shaping capabilities on the Cisco 10000 Series. A single LAC can support
subscriber sessions for many remote ISPs, and it is common to provision a unique L2TP tunnel per destination ISP.
Remote Access to MPLS
Remote Access to MPLS (RA-MPLS) offers service providers an alternative to L2TP for the provisioning of wholesale
services. Instead of building unique L2TP tunnels per ISP, a unique VPN per ISP is provisioned over an MPLS core
(Figure 5). Layer 2 access protocols are terminated at the service provider's edge and placed into the appropriate
VPN. Subscriber traffic is routed through the VPN to the destination ISP's network, and then onto the Internet.
Figure 5
RA-MPLS
Subscriber
The Cisco 10000 Series operates as a highly flexible provider edge MPLS device, supporting the widest range of Layer
2 encapsulations. It offers an array of per-VPN services, including Hot Standby Router Protocol (HSRP), AAA/
RADIUS, and DHCP.
All contents are Copyright © 1992–2003 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Cisco
10000
ATM
DSLAM
Series
LAC
IP
PPPoA or PPPoEoA
ATM
Cisco
10000
ATM
DSLAM
Series
PE
IP
RFC 1483/RBE or PPPoX
ATM
Cisco Systems, Inc.
Page 6 of 12
RADIUS/AAA RADIUS/AAA
IP Network
LNS
IP/PPP
L2TP
RADIUS/AAA RADIUS/AAA
IP Network
P P
P
P
PE
IP
MPLS VPN