Asko 2002 Vrs 2.0 Manual page 12

Electrical And Water Requirements – EasyInstall
ASKO's dishwashers come with all the connections you need. We've eliminated the need to get into the electrical and
mechanical area, which makes installation simple and quick. If a dishwasher is being installed in an area for the first time,
most of the cabinetwork, plumbing, and electrical has to be done before you move the machine into place. If you are
replacing an old dishwasher, you must check the plumbing connection and wiring before you install the new dishwasher.
This system has these components which have been approved by regulatory authorities (cUL):
• Over 5' of Pex hose that replaces the water-inlet copper tubing. It has a 3/8"-compression fitting that mates with the
shut-off valve. Length: 5'2" from back of unit.
• Over 6' of drain hose with an adaptable drain connection. The high loop is built into this hose on the back of the unit.
If this loop is removed to lengthen the hose, another high-loop must be built into the installation somewhere along the
line (typically where the hose passes through the cabinet). Length: 6'6" from back of unit.
• A 6' long electrical cord with standard, 3-pronged, 110V plug. This eliminates the need to wire anything under the unit.
Drain hose with multiple
size adaptor.
10
Back of ASKO dishwasher with
EasyInstall system.
™ Dishwashers
Each unit comes already
wired with a standard
three-pronged plug.
Pex hose with 3/8" brass fitting.