Replacing The Filter - FilterStream AirTamer Professional A710 Instruction Manual

Replacing the Filter

Please follow these steps to replace your AirTamer®
AIR FILTER.
1. Turn the AirTamer® off by pressing the
POWER BUTTON and unplugging the unit
from the electrical outlet.
2. Remove the
on the AIR EXIT GRILL TABS (2a) and pulling
the AIR EXIT GRILL (2b) away from the unit.
3. Remove the
the sides of the AIR FILTER and pulling the
AIR FILTER out of the unit.
4. Mark the suggested month of
replacement on the new AIR FILTER by
checking off the appropriate month (e.g. If it
is suggested that the AIR FILTER be replaced
in twelve (12) months and you install the AIR
FILTER on January 1st, put a check in the box
beside the letter representing the month to
replace – in this case January, for the next
January.).
5. Insert the new
bottom of the AIR FILTER inside your
AirTamer® and pushing it past the large front
rubber tab. Then push the top of the AIR
FILTER past the large front rubber tab at the
top of the unit.
NOTE:
make sure ThaT The air floW
arroWs face ToWards The froNT
of The uNiT.
6. Replace the
7. Press and hold down the
LIGhT BUTTON for three (3) seconds to reset
the ChANGE FILTER memory.
makes life better!
AIR EXIT GRILL by pushing down
AIR FILTER by firmly gripping
AIR FILTER by placing the
AIR EXIT GRILL.
ChANGE FILTER
AIR FILTER
2a
2b
3
5
6
7
Page 13