Advertisement
Quick Links
DECORATIVE LIGHTHOUSE
SOLAR LIGHT
91233
ASSEMBLY & OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web Site at www.harborfreight.com
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
©
®
Copyright
2004 by Harbor Freight Tools
. All rights reserved. No portion of this manual
or any artwork contained herein may be reproduced in any shape or form without the express
written consent of Harbor Freight Tools.
For technical questions and replacement parts please call 1-800-444-3353.
Advertisement
Summary of Contents for Bumble Bee SOLAR LIGHT 91233
- Page 1 DECORATIVE LIGHTHOUSE SOLAR LIGHT 91233 ASSEMBLY & OPERATING INSTRUCTIONS ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web Site at www.harborfreight.com READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE. © ® Copyright 2004 by Harbor Freight Tools .
- Page 2 HANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model______________ Serial No._____________ Purchase Date_______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications Construction: Polystyrene Lighthouse, Crystalline/Silicone Solar Panel Water Resistant...
- Page 3 Dress properly. Protective, electrically nonconductive clothes and nonskid footwear are recommended when working with the Lighthouse Solar Light. Wear restrictive hair covering to contain long hair. Use eye protection. Always wear ANSI approved impact safety goggles when setting up this product.
- Page 4 Located on the bottom of the Lighthouse Solar Light is a panel with a “ON”/”OFF” Button (1)-see Figure 1. Pressing down on the “ON”/”OFF” Button (1) will turn the Lighthouse Solar Light on or off. After the initial charge (Step 2) is set, check to see that the Light (3) is on by viewing the Lighthouse with the solar panel covered.
- Page 5 Battery (7) Figure 3 Replace the Rubber Panel (6) and the Top Panel (5) of the Battery Compartment. Thread back in all four (4) Phillips Head Screws (4). Unpacking When unpacking the Lighthouse Solar Light, check to make sure the following parts are included.