Advertisement
Available languages
Available languages
Your Pridiom dehumidifier features a microprocessor
based digital control
system for optimal performance control.
All functions are accessible via the membrane keypad shown below:
Humidity
Humidity &
Temperature
Setting
Humidity
Temperature
Timer
Display
On/Off
Display
Adjust
Display
Set
Select
Select
Fan Speed
Fan Speed
Select
Display
Functions:
ON/OFF
The unit is switched on and off by pressing the 'ON/OFF' button. When the
unit is on, the fan runs in the set speed.
Humidity
Press the 'HUMJDFY ADJUST' buttons repeatedly to choose the desired level
of relative humidity in the area. The corresponding
control lights will indicate
the selected percentage. The 'CONT' control light indicates that the unit is
running continuously,
disregarding the relative humidity level in the area.
Note: When the desired level of humidity is achieved the compressor will stop
however, the fan will continue to run for approximately
15 minutes, this will
clear the heat exchanger of all collected water.
Fan speed
Press the 'FAN SPEED SELECT' button to select low or high speed. The cop
responding
control light will indicate this, Lo=low or Hi=high.
Humidity / Temperature
display
The digital display will normally show the measured relative humidity in the
area.
Advertisement
