Overload Protector; Brushes; Bevel Pointer; Maintenance - DeWalt DW788 Instruction Manual

FIG. 9
BEVEL LOCK K NOB
BEVEL POINTER
FIG. !0
BEVEL SCALE
FIG. 11
BRUSH
INSPECTION
CAPS
FUSE C AP
(PRESS TO RELEASE)
NOTE: Donotliftsawbyupper arm.Damage willoccur.
Overload Protector
Your scroll saw is equipped with a 3 amp overload protection fuse. If
your scroll saw becomes overloaded and stops operating, turn off the
scroll saw, check for a blown fuse by removing the fuse cap
(Figure 11). Your scroll saw uses fuse #3AG Fast Acting,
1 1/4" long x 1/4" diameter.
Maintenance
BRUSHES
Inspect carbon brushes regularly by unplugging tool, removing the
brush inspection cap (Figure 11 ) and withdrawing the brush assembly.
Keep brushes clean and sliding freely in their guides. Always replace
a used brush in the same orientation in the holder as it was prior to its
removal. If the brush is worn down to 3/8", it must be replaced. Use
only identical DEWALT brushes. New brush assemblies are available