Advertisement
SAFETY INSTRUCTIONS cont.
SAFETY RULES FOR BATTERY CHARGER cont.
10. Do not disassemble charger. Take it to a qualified service dealer
when service or repair is required. Incorrect reassembly may result in a risk of
electric shock or fire.
11. Disconnect charger from the power supply when not in use. This will reduce
the risk of electric shock or damage if metal items should fall into the opening in
the charger. It also will help prevent damage during a power surge.
12. Risk of electric shock. Do not touch un-insulated portion of output connector
or un-insulated battery terminal.
13. Save these instructions. Refer to them frequently and use them to instruct
others who may use this tool. If you loan someone this tool, also loan them these
instructions to prevent misuse of the product and possible injury.
ADDITIONAL RULES FOR SAFE OPERATION
WARNING:
BE SURE to read and understand all instructions. Failure
!
to follow all instructions listed below may result in electric shock, fire \
and / or serious personal injury.
1. ALWAYS wear safety glasses or eye shields when using this tool. Everyday
eyeglasses have only impact-resistant lenses; they are NOT safety glasses.
2. PROTECT your lungs. Wear a face mask, dust mask or respirator if the operation is
dusty.
3. PROTECT your hearing. Wear appropriate personal hearing protection during
use. Under some conditions noise from this product may contribute to hearing loss.
4. ALL VISITORS AND BYSTANDERS MUST wear the same safety equipment that
the operator of the tool wears.
5. ALWAYS check the tool for damaged parts. Before further use of the tool, a
guard or other part that is damaged should be carefully checked to determine if it
will operate properly and perform its intended function. Check for misalignment or
binding of moving parts, breakage of parts, and any other condition that may affect
the tool's operation. A guard or other part that is damaged should be properly
repaired or replaced at a Sears Service center.
SAVE THESE INSTRUCTIONS.
6.
use them to instruct others who may use this tool. If someone borrows this
tool, make sure they have these instructions also.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
10
Refer to them frequently and
UNPACKING (Fig. 1)
1. The trimmer comes assembled except for the guard, edge guide wheels and
auxiliary handle, which must be attached.
2. Remove the trimmer, auxiliary handle, safety guard, edge guide wheels, box containing
the battery pack and charger from the carton and inspect your trimmer.
3. Do not discard box or packing material until all parts are examined.
WARNING:
If any part of the trimmer is missing or damaged, do not
!
install the battery pack into the trimmer until the damaged part is repaired
or replaced.
Fig. 1
Knob and Screw to
Loosen or Tighten
Handle (This knob
comes attached to
the auxiliary handle
and mounts on
this [right] side)
Trimmer
Edge Guide Wheels
11
Battery Charger
Auxiliary Handle
Battery Pack
Safety Guard
Hide quick links:
Advertisement
