Materials And Basic Tools Needed; Materials Needed; Basic Tools; Additional Tools Needed When Sweat Soldering - Kenmore 153.329264 Owner's Manual

MATERIALS AND BASIC TOOLS NEEDED

Materials Needed

To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
WATER HEATER INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR 3/4" OR 1/2"
THREADED OR COPPER PLUMBING.

Basic Tools

You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Folding Rule
Garden Hose
Drill
Pipe Dope or Teflon Tape
ROLL OF TEFLON TAPE (USE ON
WATER CONNECTIONS)
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER CONNECTIONS
GARDEN HOSE 6 FOOT TAPE
EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE IN 2
GALLONS , AND 5 GALLONS CAPACITY
THROUGH LOCAL SEARS STORE OR
SERVICE CENTER.
DRILL
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
PIPE WRENCH
6
Additional Tools Needed When Sweat
Soldering
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
ROLL OF
EMERY CLOTH
3/4" (19 mm) WIRE BRUSH
PROPANE
TORCH 1/2" (13 mm) WIRE BRUSH
DRAIN PANS AVAILABLE IN 20"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18" OR LESS,
24" DIAMETER FOR WATER
HEATERS HAVING A DIAMETER 22"
OR LESS AND AVAILABLE IN 28"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26" OR LESS.
TUBING CUTTER
HACKSAW
ROLL OF
SOLDER
LEAD-FREE
FLUX
SOFT SOLDER