Galaxy One-Speed Automatic Washers Owner's Manual & Installation Instructions page 25

Problem Possible Cause Solution
Won't Drain/ Low voltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Do not use extension
Wet Loads cords.
(cont,)
Cold rinses. Cold rinses leave loads wetter than
warm rinses. This is normal.
Continues Drain hose is less than Raise the drain hose (see
to Fill/ 39 in. (99 cm) above floor. "Installation Requirements"),
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see "Installation Instructions").
Drain hose taped into Do not seal off drain hose with tape.
standpipe. The drain hose needs an air gap.
Washer Makes Load is unbalanced. Redistribute Ioad.
Noise
Washer is not level, Level washer. Reset rear legs
Rear leveling legs not set. (see "Installation Instructions"),
Nuts on front feet not tight. Tighten nuts (see "Installation
Instructions").
Yellow shipping strap with Remove strap with cotter pins
cotter pins not completely (see "Installation Instructions").
removed.
Floor not strong enough Relocate washer (see "Installation
to support washer. Requirements").
Gears engaging after drain This is normal.
and before spin.
Upper part of agitator clicks This is normal.
during wash.
Won't Water inlet valve Clean screens.
Fill/Won't screens are plugged.
Rinse/Won't
Agitate/ Water is turned off. Turn on water.
Wrong Hot and cold hoses are Reverse hoses (see "Installation
Temperature reversed. Instructions").
Inlet hose is kinked. Straighten hoses.
Timer dial is not lined up. Tam timer knob to the right slightly
and pulI to start.
Power cord not plugged in. Plug into a grounded 3 prong outlet.
25