AnaCise Platform Interface Module GigE Triple Play PIM PIM 415/D-GigE Specification Sheet

Platform Interface Module
GigE Triple Play PIM
PIM 41S/D-GigE
General
Operation Modes
BERT, IP QoS, RFC2544, Monitor, Service Tool and NIC for
Triple Play Analysis Suite–IPTV, VoIP, Data
Physical Interfaces
Single or Dual 10/100/1000Base-T Electrical UTP (RJ-45)
and 1000Base-X Optical (SFP) port
Standard Supported
IEEE 802.3 2005 Compliance
LED Indicators
Module: On or Off
IF/LB: SFP (Optical), UTP (Copper) or loop back
Link: Signal or Loss (SFP), Link Up or Down (UTP)
Speed: 1G (SFP), 10M, 100M or 1000M (UTP)
Sync: Pattern Sync/Loss (BER) or Error
Laser: Laser On or Off
Port Operation
Single Port A (Term./LB, Monitor)
Single Port B (Term./LB, Monitor)
Dual Port A and Port B (Term./LB, Mon, PassThrough)
Port in Electrical or Optical
Traffic Generation
Physical
Configurable Speed, Duplex, Flow Control (Auto/Manual),
and Remote Loop back L1/L2/L3
IP Version
IP V4 or IP V6
Frame Formats
EtherType II (DIX v.2)
IEEE 802.3–LLC1 and IEEE 802.3–SNAP
Layer 1, MAC, MAC+IP, MAC+IP+UDP
Streams
Up to 256 multi-streams per port in Uniform Traffic Profile
- Source/Destination MAC/IP and VLAN addresses with
traffic load averaged
Up to 4 multi-streams per port in Individual Traffic Profile
- Addresses, Prioritization/IP header, Frame size,
Payload, Traffic load
Addresses
Source/Destination MAC/IP and VLAN ID (Single/Stack
Q-In-Q), ARP/DHCP supported
Prioritization
VLAN ID (802.1Q)/Priority (801.p), and IP TOS/Cisco
DiffServ DSCP
IP Header
Prioritization, TTL, UDP/TCP/HOPOPT
Traffic Load
Up to full wire speed in Line Utilization %, Line Rate in
Kbps, Frame Rate in FPS and Frame Gap
Frame Size
64~2040 Bytes, including Under/Oversize and Jumbo
Duration
Infinite, the Number of Frames, and Timed
GigE Triple Play PIM
Specification Sheet
Payload
PRBS, CJPAT, CRPAT, All-0s, All-1s, ALT1/0
Shaping
Constant, Ramp and Burst
Error Insertion
BE (BERT), CRC, IP Checksum and Alignment
QoS Test
Operation
IP QoS test in asymmetric or symmetrical testing
Remote Loop back with MAC/IP S/D addresses swapped
automatically
QoS Index Inserted
Anacise QoS Test Payload with sequence no. and timing
inserted for the validation of Triple Play service
Timing Resolution
40 ns for all timing parameter measurements
Payload
2 15 -1, 2 20 -1, 2 23 -1, and 2 31
QoS Measurements
Network Delay in ms (Current, Min, Max, and Avg)
Inter-Arrival Time (Current, Min, Max, and Avg)
Jitter Distribution Analysis Diagram
Packet Loss (Count, Ratio)
Out of Sequence (Count, Ratio)
QoS result is classified per the standard of ITU-T Y.1541
Network Performance Objectives for IP-Based Service
Traffic Statistics
Same as the traffic statistics–Physical and Frame layer in
Monitor mode
Multi-BERTs
Operation
Single BERT with Uniform multi-streams in P-t-P, P-t-LB
Multi-BERTs with Individual multi-streams in P-t-P, P-t-MP
and P-t-LB
BER Testing in Asymmetrical or Symmetrical testing
Loop back with MAC/IP source/destination addresses
swapped automatically
Patterns
2 15 -1, 2 20 -1, 2 23 -1, and 2 31
Long Continuous Random Test Pattern (CRPAT)
Long Continuous Jitter Test Pattern (CJPAT)
All-0s, All-1s, ALT1/0
BER Results
Individual Stream-based :
BER count/BER %, Frame sync loss count/time,
Pattern Sync Loss time, BER frames received,
Utilization% and FPS
Port-based :
CRC error count/rate, IP checksum error count/rate,
Packet loss, Sequence error, Alignment, Line-rate
Traffic Statistics
Same as the traffic statistics–Physical and Frame layer in
Monitor mode
March 2008
-1, with pattern inverted option
-1, with pattern inverted option
Page 1 of 2