Table of Contents
Advertisement
16
operatIng technIques
warning
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause unconscious-
ness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed
away from your face and body.
1. Before edging, water the area to soften the ground to make edging
easier.
2
Before edging, check the area and remove all obstacles and ob-
jects that could be thrown.
3.
Plan to edge regularly to make it easier to keep a neat edge and to
avoid having to make more than one pass.
NOTE
Blade depth may have to be adjusted due to differences in height
between the hard surface and the top of the grass.
warning
Never adjust blade height with engine running, otherwise serious
personal injury may result.
4. Loosen adjustment knob and adjust the blade's depth of cut to
produce a fine cut between sidewalk and grass using a minimum
blade depth, usually with about 13 mm (1/2 in.) of the blade into
the ground. Tighten adjustment knob.
5. Before edging, plan your direction of travel so that the unit will
always be positioned on your right side and so that you walk on a
hard surface whenever possible.
6. Hold edger as shown.
warning
Before edging, be sure to read and understand the entire Operator's
Manual to avoid the chance of serious injury.
7. When starting to edge, run the engine at full throttle, and lower
the blade gently into the ground, being careful not to hit the con-
crete with the blade.
8. Don't force the blade. Move as quickly as the blade will allow.
warning
The complete unit, specifically the drive shaft assembly and muf-
fler exhaust area may become very hot during use. Avoid contact
during and immediately after operation, otherwise serious personal
injury may result.
wHEEL
1/2 in.
aDJUSTMEnT
KnOB
inCrEaSE
DEPTH
DECrEaSE
DEPTH
Advertisement
Table of Contents
