Channel Settings; Autoscan - iLO CIWL3706 Owner's Manual

C
HANNEL SETTINGS

AUTOSCAN

If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with [CH K / L ] and the TV
memorizes them even if you switch wires.
- 0
SETUP SETUP
BACK
CH RETURN
VOL.
NOTE:
• Make sure the TV is connected to antenna or cable.
1
Display the setup screen.
• Press [SETUP].
The following setup screen is displayed.
2
Select "CHANNEL" and press [ENTER] to con-
firm.
• Using [ K / L ], select "Autoscan".
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
• Press [ENTER].
STILL
SCREEN
MODE
ENTER ENTER
INFO
CH
MUTE
3
For TV channels, using [ K / L ], select "Air".
For CATV channels, select "Cable".
Autoscan Autoscan
Autoscan will rescan all channels.
This may take a while to complete.
Select the destination of "ANT IN" jack.
Air
Cable Or
ANT IN
• Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
Now the system is scanning for channels, please wait.
72%
Analog channels
Digital channels
SETUP
Exit
• When the scanning and memorizing are com-
pleted, the lowest memorized channel in the
broadcasting will be displayed.
NOTES:
• If you connect a cable system directly, contact the
CATV installer.
• If you press [POWER] or [SETUP] during Autoscan, this
setting will be canceled.
• If there is no reception connected or poor signal is detected,
a Hint will appear on screen once scanning stops.
Back
Air
Cable
Cable
1hour
10ch
6ch
13
EN