Desa Unvented (Vent-Free) Gas Compact Classic Hearth Fireplace VMH26NRB Owner's Operation And Installation Manual page 20

Unvented (vent-free) gas compact classic hearth fireplace
Hide thumbs Also See for Unvented (Vent-Free) Gas Compact Classic Hearth Fireplace VMH26NRB:
Table of Contents

Advertisement

PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure
25, page 19).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of fireplace is in
the OFF position.
4. Check all joints from equipment shutoff
valve to gas control valve (see Figures
26 or 27, page 19). Apply noncorrosive
leak detection fluid to all joints. Bubbles
forming show a leak.
5. Correct all leaks at once.
6. Light fireplace (see Operation, page 23).
Check all other internal joints for leaks.
7. Turn off fireplace (see To Turn Off Gas to
Appliance, page 24).
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(HRC100 Series & HRC200 Series)
Installing Receiver
1. Remove screws.
2. Disconnect switch wires from control
valve.
3. Remove switch plate (see Figure 28).
Discard switch plate after removing. Save
the screws.
4. Locate battery clip mounted on back of
receiver (see Figure 29).
5. Slide 9-volt battery (not included) through
the clip.
6. Attach terminal wires to battery (see Fig-
ure 29).
Screw
Black
Wire
Figure 28 - Switch Plate and Wiring
Harness
20
INSTALLATION
Continued
7. Connect wires as shown in Figure 31.
8. Install remote receiver unit onto fireplace
Receiver
Figure 29 - Attaching Battery to Receiver
Wire Harness*
Wires from
Valve
Figure 30 - Installing Remote Receiver
* Wire harness provided in the fireplace
hardware pack.
Switch
Plate
Installing 9-Volt battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
Red Wire
2. Attach terminal wires to battery (not includ-
3. Replace battery cover onto remote control
www.desatech.com
base using two screws removed in step
one (see Figure 30).
9-Volt Battery
Black Wire
Black
Wire
control unit (see Figure 31, page 21).
ed). Place battery into battery housing.
unit (see Figure 31, page 21).
Terminal
Wires
Battery Clip
Remote Receiver
Red Wire
Red
Wire
113110-01H

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vmh26prb

Table of Contents