Download Print this page
CrimeStopper TN-4011 Install Manual
Hide thumbs Also See for TN-4011:

Advertisement

Quick Links

TN-4011 Install Guide
1. Select the mounting locations for the Device and Antenna. Do not mount the Device or
the Antenna under the hood or expose to outside elements.
2. Make sure the "SIM Card Lock" is positioned to the locked position (to the left). The
device will not obtain a cellular connection if it is not in the locked position.
3. The Antenna is designed to mount inside the vehicle. The "AIRWARD" emblem
represents the top of the Antenna, and must face up (skyward). The side with the
adhesive (3M Tape) must face down if it is a square antenna. NOTE: If you are using a
round antenna the side with the adhesive (3M Tape) must be up. I t is strongly
recommended that the Antenna be mounted under the vehicle dash in a hidden location
with line of sight to the sky through the windshield. The Antenna will not work if the line
of sight is blocked by metal. Make sure the glass does not have any metal film at base as
that will block the GPS signal. The antenna must not be in contact with anything metallic,
or covered by any metallic objects to work properly Do not crimp or route antenna
cables. Use caution when using tie-straps for the antenna. Over tightening could cut off
the signal to the device. Adhesive is located on the antenna to secure placement.
Adhesives such as two sided sticky tape, Velcro, and silicone are often used to secure
placement of the antenna. Two sided stick tape can weaken under prolonged exposure to
extreme heat causing the antenna to fall and turn upside down causing "Old GPS Data"
information.
4. WIRING CONNECTIONS. (Make connections, but do not plug into Device)
a. BLACK WIRE- Chassis Ground. Connect to a solid chassis ground.
b. RED WIRE- 12V+ Constant Input. Connect to a constant 12volt power source.
c. WHITE WIRE- Connect this wire to a Switched 12 volt power source. (Ignition or
Accessory)
d. YELLOW WIRE- Negative PTO input wire.
e. BLUE WIRE- Positive PTO input wire. This wire must rest at ground and go high to
operate correctly.
f. GREEN WIRE- Not used
1770 S. Tapo Street, Simi Valley, CA 93063 Phone: 800.998.6880
5. Hand-tighten Antenna connectors to "GPS ANT" and "MODEM ANT" outlets on
Device. Do not power the device without the GSM connector secured to the device.

Advertisement

loading

Summary of Contents for CrimeStopper TN-4011

  • Page 1 TN-4011 Install Guide 1. Select the mounting locations for the Device and Antenna. Do not mount the Device or the Antenna under the hood or expose to outside elements. 2. Make sure the “SIM Card Lock” is positioned to the locked position (to the left). The device will not obtain a cellular connection if it is not in the locked position.
  • Page 2 Powering up the Device without the GSM connector secured may result in product failure. 6. Plug in supplied wire harness to Device. Ground/Black wire should be on far left side of Device matching to (Ground) on Device front panel. Match Power/Red wire to VIN (Voltage IN) on Device.