Asus W3000A Series Service Manual
  1. Manuals
  2. Brands
  3. Asus Manuals
  4. Laptop
  5. W3000A Series
  6. Service manual
Asus W3000A Series Service Manual

Asus W3000A Series Service Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Disassembly Procedure

Please follow the information provided in this section to perform the complete
disassembly procedure of the notebook.
described before.
A
SUS W3000A Series Notebook consists of various modules. This chapter describes the
procedures for the complete notebook disassembly. In addition, in between procedures, the
detailed disassembly procedure of individual modules will be provided for your service needs.
The disassembly procedure consists of the following steps:
•
Battery Module
•
HDD Module
•
Optical Drive Module
•
CPU Module
•
Second Memory Module
•
Mini PCI Module
•
Keyboard Module
•
First Memory Module
•
LCD Module
•
Top Case Module
•
Motherboard Module
Be sure to use proper tools
3 - 1
disassembly procedure
Chapter
3
W3A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W3000A Series and is the answer not in the manual?

Questions and answers

Related Manuals for Asus W3000A Series

Summary of Contents for Asus W3000A Series

  • Page 1: Disassembly Procedure

    Be sure to use proper tools described before. SUS W3000A Series Notebook consists of various modules. This chapter describes the procedures for the complete notebook disassembly. In addition, in between procedures, the detailed disassembly procedure of individual modules will be provided for your service needs.

  • Page 2: Battery Module

    disassembly procedure Battery Module B A T T E R Y The illustration below shows how to remove the battery module. 1. Press latch to open the battery module, then lift battery module away from the system. HDD Module H D D The illustrations below show how to remove the HDD module from the notebook.

  • Page 3: Optical Drive Module

    disassembly procedure Optical Drive Module O P T I C A L Press latch here then pull it out. D R I V E R E M O V A L CPU Module C P U M O D U L E The illustrations below show how to remove the CPU module from the notebook.
  • Page 4 disassembly procedure 3. Remove the 4 screws (M2*4L(K)) upon the thermal module and take away the CPU heat sink module gently 4. Turn the non-removable screw here 180 degrees counter-clockwise to loosen the CPU and take the CPU away Note: If thermal module has no thermal pad on it, please plus a thermal pad on the CPU die before assembling.

  • Page 5: Wireless Lan Module

    Second Memory Module S E C O N D The W3000A Series Notebook does not have onboard RAM. There are two SO-DIMM sockets for M E M O R Y installing SO-DIMM RAM. It can upgrade the total memory size up to 2GB with a 1GB module on each M O D U L E socket.

  • Page 6: Keyboard Module

    disassembly procedure Remove the Wireless LAN module by opening the 2 latches aside, which will pop the module up to an angle of 30°, then pull out the module in that angle just like memory module. Keyboard Module K E Y B O A R D The illustration of below shows how to remove the keyboard Removing Keyboard and Keyboard Cover K / B...

  • Page 7: Lcd Module

    disassembly procedure First Memory Module F I R S T M E M O R Y 1. The first memory module is under keyboard. Push the memory cover to the left side and lift the M O D U L E memory cover and open the two latches to pop up memory module at 45 degrees angle then pull it R E M O V A L out.
  • Page 8 disassembly procedure 3. Remove Antenna and switch cable. 4. Remove 2 screws(M2*8L(K)) on bottom case M2*8L 5. Remove 2 screws(M2*8L(K)) on both ends 3 - 8...
  • Page 9 disassembly procedure M2*8L 6. Take away the LCD Module Removing LCD Module L C D 1. Remove 5 rubber pads and 5 screws(M2 x 4L) from LCD module. R E M O V A L Prying the inside edges of the top front bezel, then separate it from LCD back cover and take 3 - 9...
  • Page 10 disassembly procedure LCD front bezel away. Disconnect both inverter cable. Remove 1 screws (M2*4L(K)) and 2 screws (M2*3L(K)) take Inverter board off. Remove 8 screws(M2*4L(K)) and take the LCD panel off . L C D D I S A S S E M B L Y 3 - 10...
  • Page 11 disassembly procedure M2*4L Remove 2 tapes and dissconnect coaxial cable then take it away. Finally, Remove 4 screws(M2*3L(K)) on the right LCD bracket , and 4 screws on the ilft side to disassemble LCD brackets. M2*3L M2*3L Remove 1 screw(M2*4L(K)) and take the swtich board off. 3 - 11...
  • Page 12 disassembly procedure Secure 1 screw(M2*4L(K)) on left and right side hing,then take right and left hinge off. 10. Take away the Power button. 11. Remove 2 screws (M2*4L(K))and take away both antennas 3 - 12...
  • Page 13 disassembly procedure Removing Top Case Module T O P C A S E M O D U L E 1. Disconnect All FPC on top case. R E M O V E 2. Remove 8 screws (M2*4L(K)) on the top case and 8 screws (M2*4L(K) on the bottom case. M2*4L M2*4L 3 - 13...
  • Page 14 disassembly procedure 3. Separate the top case module from the bottom case module. 4. Remove 4 screws(M2*4L(K)) and take away both speaker. 5. Disconnect touch pad FPC cables and remove 5 screws(M2*3L(K)) then take touch pad backet off and take touch pad away. 3 - 14...
  • Page 15 disassembly procedure 6. Remove 6 scews (M2*2L(K)) and take away both side key modules Motherboard module M O T H E R B O A R D The illustrations below show how to disassemble and remove the Motherboard module, the blue M O D U L E tooth module and the modem module.
  • Page 16 disassembly procedure M2*4L 3. Turn the mother board around, remove 2 screws (M2*4L(K)), disconnect the modem cable. M2*4L 4. Remove the blue tooth module. 3 - 16...
  • Page 17 disassembly procedure 5. Remove 2 screws (M2*8L(K))and remove the ODD connector M2*8L 6. Remove the power cable and 1 screw to remove the DC-in jack board. 3 - 17...

Table of Contents