Autopage XT-35 for CPX-2600 & CPX-3600 Manual

XT-35 Transmitter for the CPX-2600 & CPX-3600

PROGRAMMING TRANSMITTER:

Enter:

1. Turn the Ignition switch "OFF/ON" 3 TIMES and stay in ON position. Within 15 seconds,
2. Push the Valet switch 3 times (hold in on the 3
release the valet switch. You are now in the Transmitter programming mode.

Program:

1. Press any button on the first transmitter until the siren responds with a confirming chirp; the
first transmitter is now programmed.
2. Press any button on the second transmitter until the siren responds with a confirming chirp;
the second transmitter is now programmed.
3. Apply the same procedure to program any 3rd and 4
Exit: Turn Ignition to "OFF" position, or leave it for 15 seconds. Three long chirps will confirm

exit.

Note: If more than 4 transmitters programmed, the system will only keep the last 4 transmitters.
PROGRAMMING
rd
push); when one long chirp is heard then
th
transmitters.