GE AGV18 Owner's Manual & Installation Instructions page 4

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool on
Fanon
Energy
Saveroi
FAN SPEED
TIMER MODE
Air ConditionerControls
Remote Control
Controls
O ON/OFF Pad
Turns air conditioner on and off.
oisplav
Shows the set temi)eramre or time remaining
on tilller.
O MODE
Use to set the air conditioner to COOL or
FAN m ode,
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
O FAN Pad
Use to set the tim speed to LOW(F1), MED (F2)
or HIGH (F3).
O ENERGYSAVER
(on some models)
Controls the tim.
O/_--T1Ee tim and c()mi)ressor c)'cle on and
off. This restflts in wider w_riafions of room
temperature and htEmidip,'. Nommllv used
when the room is tmoccuI)ied. NOTE:
Thefan
wi// continue to run for a short time after the
compressorcyclesoff.
OFF
The tim runs all the time, while the
COIIII)I'eSSOI"
cycles
on [In(1 oJZ{ ',
This teattEre must be set at
OFF
in order to use
the fire settings (on the mode control).
NOTE: Onsome models, the ENERGY SAVER feature
cannot be set on the air cond/tione_It must be set uslhg
the remote control
O CIRCIJLAIRE(on some models)
FoY confintlOtlS side-to-side air cii'ct/lation
(cool settings only), set the CirctElaire switch
to ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF.
O TIMER Pad
O_k--_ 1Een the air conditioner is off, it can be
set to atEtomatically come on in 1 to 12 hotu_
or 1 to 24 1EOm_ (depending on model) at its
previous setting. Each touch
of the TIMER pad
or the INCREASE&/DECREASE• pads
(dei)ending on model) will set the diner
in 1EOm_.
OFF _]Een the air conditioner is on, it can be
set to automatically tEEm off in 1 to 12 lEom_ or
1 to 241EOm5 (depending on model). Each
touch of the TIMER pad or the INCREASEA /
DECREASE• pads (depending
on model) will
set the timer in IEOEH_.
TOcancel the timer, press the TIMER pad tmtil
the display time disappeax_.
O Remote Control Signal Receiver
4
Remote Control
::Ji:: To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
iJi:: T he remote control signal has a range of
tl I) tO
21
teet.
::Ji:: Make sure nothing is between the air conditioner
and the remote control that cotfld block the
signal.
::Ji:: Make sure batteries are fl'esh and installed
correctly as indicated on the remote control.