Advertisement
Table of Contents
Warnings & Important Information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3
RVCH Classic Chimney Wall Hoods w/Standard Ventilator
Dimensions & Specifications_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5
Clearance Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6
Interior Ventilator Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7
Planning Information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8
Installation Procedure
Installation (RVCH Classic Chimney Wall Hoods w/Standard Ventilator) _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9
Duct Cover (RVCH Classic Chimney Wall Hoods w/Standard Ventilator)_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11
Installation (RVCH Classic Chimney Wall Hoods w/Recirculating Kit) _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12
Service & Registration _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 15
2
IMPORTANT-
Please Read and Follow!
NOTE: If installing hood with warming shelf panel,
install warming shelf panel first.
IMPORTANT - PLEASE READ AND FOLLOW
• Before beginning, please read these instructions
completely and carefully.
1. Installation work and electrical wiring must be
• DO NOT remove permanently affixed labels,
warnings, or plates from the product. This may
void the warranty.
• Please observe all local and national codes and
2. Sufficient air is needed for proper combustion
ordinances. If no local codes are applicable, wire
in accordance with the National Electrical Code,
ANSI/NFPA 70-latest edition.
• The installer should leave these instructions with
the consumer who should retain for local
inspector's use and for future reference.
• Check with a qualified and trained installer or local
codes for makeup air requirement, if any.
3. When cutting or drilling into wall or ceiling, do
This hood is for residential installation only and is
not designed for installation over a commercial
product. Make sure power is off at the main circuit
4. Ducted fans must always be vented to the
breaker or fuse box before making connections. To
5.
avoid risk of fire, electric shock, or injury to persons,
turn off the electricity to the hood from the power
6.
supply before servicing or cleaning.
Viking hoods are equipped with the variable speed
controls for blowers. These units will not function
with a single speed ventilator. All Viking ventilator
7.
kits are designed specifically for use with Viking
hoods. Use of any non-Viking ventilator kit will void
the hood warranty.
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G
1. Never leave surface units unattended at
high setting. Boilovers cause smoking and
greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
2. Always turn hood ON when cooking at
high heat or when cooking flaming foods.
(i.e. crepes suzette, cherries jubilee,
• Use this unit only in the manner intended by the
peppercorn beef flambé).
3. Clean ventilating fans frequently. Grease
should not be allowed to accumulate on
• Before servicing or cleaning unit, switch power off
fan or filter.
4. Use proper pan size. Always use
cookware appropriate for the size of the
surface element.
3
W A R N I N G
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
and exhausting of gases through the flute
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer's guideline and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the
local code authorities.
not damage electrical wiring or other hidden
utilities.
outdoors.
To reduce risk of fire, use only
metal ductwork.
To reduce risk of fire and to
properly exhaust air, be sure to duct air outside.
Do not vent exhaust air into spaces within walls
or ceilings, or into attics, crawl spaces, or
garages.
To Reduce the Risk of Fire and
Electric Shock, Install this range hood only with
remote blower models manufactured by Viking,
model numbers - DEV900/DEV1200,
VEV900/VEV1200, OR DEV1500, VEV1500 or
integral blowers manufactured by Viking, model
numbers - DIV300, DIV440, DIV600, DIV800,
DIV1200, VIV300, VIV600, or VIV1200.
- Please refer inside for specific
canopy/blower combinations.
W A R N I N G
manufacturer. If you have any questions, contact
the manufacturer.
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Advertisement
