Iwrap Error Messages; Hci Errors - Bluegiga IWIP3G - IWRAP - IPHONE 3G User Manual

8. IWRAP ERROR MESSAGES

This chapter briefly presents the iWRAP error messages.

8.1 HCI Errors

HCI errors start with code: 0x100
ERROR MESSAGE
HCI_SUCCESS
HCI_ERROR_ILLEGAL_COMMAND
HCI_ERROR_NO_CONNECTION
HCI_ERROR_HARDWARE_FAIL
HCI_ERROR_PAGE_TIMEOUT
HCI_ERROR_AUTH_FAIL
HCI_ERROR_KEY_MISSING
HCI_ERROR_MEMORY_FULL
HCI_ERROR_CONN_TIMEOUT
HCI_ERROR_MAX_NR_OF_CONNS
HCI_ERROR_MAX_NR_OF_SCO
HCI_ERROR_MAX_NR_OF_ACL
HCI_ERROR_COMMAND_DISALLOWED
HCI_ERROR_REJ_BY_REMOTE_NO_RES
HCI_ERROR_REJ_BY_REMOTE_SEC
HCI_ERROR_REJ_BY_REMOTE_PERS
HCI_ERROR_HOST_TIMEOUT
CODE Explanation
0x00 Success
0x01 Unknown HCI command
0x02 Unknown connection identifier
0x03 Hardware Failure
0x04 Page timeout
0x05 Authentication failure
0x06 PIN or key missing
0x07 Memory capacity exceeded
0x08 Connection timeout
0x09 Connection Limit Exceeded
0x0a Synchronous connection limit to
a device exceeded
0x0b ACL Connection Already Exists
0x0c Command Disallowed
0x0d Connection
Limited Resources
0x0e Connection
Security Reasons
0x0f Connection
Unacceptable BD_ADDR
0x10 Connection
Exceeded
157
Rejected due to
Rejected Due To
Rejected due to
Accept Timeout