Honeywell HCM-646 - Humidifier With Electronic Controls Owner's Manual page 8

Digital EasySet Control Operation (Model HCM-650)
™
S T E P 4 : S E T H U M I D I T Y
• You can set your desired humidity in 1% increments
anywhere from 30% to 60%.
• To set your desired humidity, press the humidity button up
or down (Fig. 12).
• When the display indicates your desired humidity setting
wait 3 seconds.
• After 3 seconds your desired humidity is set and the display
will revert back to showing the current room humidity.
NOTE: If you wish to change your humidity setting or check
to see what you set, simply press the humidity button once
and it will show you the set humidity. If you want to change
it, continue to push the button up or down until you have
reached your new desired humidity. Again, after 3 seconds
the display will revert to showing the current room humidity.
• Once you have set your humidity the unit will operate under
this desired setting until the unit is turned off.
• When your desired room humidity has been reached your
unit will shut off and the house icon on the top of your
display will illuminate (Fig. 13). It will stay illuminated until
your desired humidity decreases at which time your unit will
turn back on.
Protec ™ Cleaning Cartridge
The Protec ™ Cleaning Cartridge will last 30 days or longer, depending on your usage. To install or replace
your cartridge, simply remove the holder on the inside of your tank cap by turning it
counter-clockwise
Fig. 14
Tank Cap
8
. Replace the cartridge holder by by turning it clockwise
Cartridge
Holder
Protec ™
Cleaning
Cartridge
Fig. 12
Fig. 13
Fig. 15
(Fig. 14 & Fig. 15).