Fujioh WS06 Installation Manual

www.fujioh.com
IMPORTANT
Must use this wiring diagram for installation.
Do not use Thermador wiring diagram.
WARNING
Electrical wiring should be done by a qualified person(s)
in accordance with all applicable codes and standards,
including fire-rated construction. An unqualified person
doing the work could result in fire, electric shock or injury.
This switch uses 120 V AC, Max 16 Amp. Do not connect
to other voltage or over current rate since fire, electric
shock or damage could result.
Be sure to switch power OFF at service panel before
wiring.
< CONNECTING POWER SUPPLY WIRES >
1. A 2-1/2" deep Wall Box must be used to allow space for
wire connections between switch and 120 volt Power
Input Leads.
2.
Connect the electrical wires in accordance with
wiring diagram (figure 1).
Connect wires tightly and securely using wire
connectors (not supplied).
3.
Attach the wall plate, and secure with 2 screws.
4. Turn on the electrical circuit to the power unit. Check
the ventilating functions at each speed control
positions. Make sure that the range hood has no
abnormal noises and/or vibration.
Your installation is now complete.
If you should require service or replacement
parts on your ventilation system.
contact:
Fuji Industrial USA,Inc.
16300 Christensen Rd, #212 Seattle, WA 98188

READ AND SAVE THESE INSTRUCTIONS.

Keep this manual in a convenient place for future reference.

INSTALLATION MANUAL

1-888-547-9880
FUJI INDUSTRIAL CO.,LTD .
WS06
Top
Switch: Red
Low speed
Switch: Yellow
Switch: Black
High speed
BLACK
/120V AC
FIG 1 < Connection Diagram >
2-1/2" Deep Wall Box
(must be grounded)
Bowers #52 or Equivalent
FIG 2
GE Switch:
ASR-4173-500
(UL Recognized
Component)
LO
OFF MED
HI
Switch: Blue
Medium speed
WHITE
/NEUTRAL
From
Blower Moter
Motor Green or
Bare Ground Wire
- Grounded to
Wall Box
030984