Loading The Battery - FujiFilm 100 Owner's Manual

LOADING THE BATTERY

Your camera uses one 3V lithium battery, type CR2/DL CR2.
To load the battery.
1 Move the battery cover release knob.
2 Open the battery cover.
2
1
3 Insert the battery following instruction in the diagram on the inside of the battery
4
cover paying particular attention to the position of the , and . poles of the bat-
tery. The battery must be inserted the right way or the camera will not function.
4 When the battery is inserted correctly, close the battery compartment cover by
pressing it until it snaps into place.
Do not apply excessive force when opening or closing the battery cover.
3
One fresh lithium battery should be sufficient for approximately 250 exposures (based on our
test conditions).
When traveling, take extra batteries to provide power for extra exposures. This is particularly
important if you visit areas where fresh batteries may be difficult to obtain.
Check the battery capacity symbol before using your camera. ( p.17)
After changing the batteries, reset the date to assure accurate date/time recording. ( p.18)
CHINESE
15