Summary of Contents for VTech Rechargeable Power Pack InnoTab 3 / 3S
- Page 1 Rechargeable Power Pack Rechargeable Power Pack 2013 © VTech User’s Manual User’s Manual Printed in China 91-009656-000...
-
Page 2: Included In This Package
INTRODUCTION The Rechargeable Power Pack makes it easier than ever to keep the InnoTab ® charged and ready to go. Install the battery packs to give the or InnoTab ® tablet its own dedicated power source. Then, plug the into a wall outlet InnoTab ®... -
Page 3: Getting Started
geTTINg sTaRTeD Installing the Rechargeable Battery Packs 1. Make sure the InnoTab 3 or InnoTab 3S is turned off. ® ® 2. Turn the unit over. Slide the battery door lock switch (or switches) forward and push the battery covers off to each side to remove them. 3. Remove any old batteries that may be in the toy. (Battery removal and replacement should be done by an adult.) 4. Insert Battery Pack① into the compartment on the right side and Battery ② into the compartment on the left side. Pack • Insert the battery pack into the connector slot first. -
Page 4: Important Notes
2. Plug one end of the AC adapter into the power jack on the InnoTab and ® plug the other end into a wall outlet. Note: The AC adapter is not a toy and should only be handled by an adult. 3. You can continue to use the InnoTab ® while the AC adapter is connected, but the batteries will not charge while the InnoTab is on. When you’re done ® playing, turn the power off and leave the tablet connected to a wall outlet to charge it. 4. The green light on the tablet will flash to indicate charging is in progress. When the batteries are fully charged the light will turn off. A full charge takes about 4.5 hours with the AC adapter that’s included in the package. Note: If the green light on the tablet flashes very quickly during charging, the battery packs may not be connected properly. Please reinstall the battery packs and try again. IMpORTaNT NOTes: 3 or InnoTab 3S is turned off before charging. • Make sure the InnoTab ® ® • The tablet will charge at temperarures between 41°F~95°F(5°C~35°C). If the tablet is not charging properly, please move it to a location with a suitable temperature. • Battery removal and replacement should only be done by an adult. • The AC adapter is not a toy and should only be handled by an adult. • Keep the connector pins on the InnoTab and the metal contacts on the ®... -
Page 5: Care And Maintenance
• Remove batteries from the toy if it will not be used for an extended period of time. • To prevent fire or electric shock, do not expose the unit to rain or moisture. • Do not repair or alter the battery packs in any situation. • Do not disassemble or reassemble the battery packs. • Batteries may contain hazardous materials, and may be nondisposable. Please contact a recycling company for a proper disposal method. • Avoid mixing batteries of different sizes and capacities in your electronic device. This charger is not a toy. This charger is not intended for use by children. Do not recharge non-rechargeable batteries. -
Page 6: Troubleshooting
TROUBleshOOTINg Problem Solution The green light does not Inspect the AC adapter. Make sure that the come on or blinks very adapter is securely connected to the InnoTab quickly when attempting and plugged in to the wall outlet. to charge the unit. Check that the rechargeable batteries are correctly installed in the tablet. -
Page 7: Disclaimer And Limitation Of Liability
Electronics North America, L.L.C. and its suppliers assume no ® responsibility for any loss or claims by third parties that may arise through the use of this product. VTech ® Electronics North America, L.L.C. and its suppliers assume no responsibility for any damage or loss caused by deletion of data as a result of malfunction, dead battery, or repairs. Be sure to make backup copies... - Page 8 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B)/NMB-3(B) Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.