Removing Or Replacing The Vanity Cover; Removing The Vanity Cover; Replacing The Vanity Cover - HP Mini 110-3700 Getting Started Manual

Removing or replacing the vanity cover

CAUTION:
Save your work and shut down the computer before adding or replacing a memory module or hard
drive.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by sliding the
power switch. Then shut down the computer through the operating system.

Removing the vanity cover

Remove the vanity cover to access the memory module slot, hard drive, regulatory label, and other
components.
To remove the vanity cover:
1. Remove the battery (1) (refer to
2. Slide the release latch (2) to the right to release the vanity cover.
3. Lift the back edge (3) of the vanity cover, and then remove the cover (4) from the computer.

Replacing the vanity cover

Replace the vanity cover after accessing the memory module slot, hard drive, regulatory label, and
other components.
To replace the vanity cover:
1. Insert the 4 tabs on the front edge of the vanity cover (1) into the 4 slots in the base.
2. Rotate the back edge (2) of the vanity cover downward, and then firmly press the cover down
until it snaps into place.
26 Chapter 6 Maintenance
To prevent information loss or an unresponsive system:
Removing the battery on page 25).