HP FM850UT - SMART BUY 4710S T6570 Notebook Maintenance And Service Manual page 98

Select
Boot Options
Device Configurations
88 Chapter 5 Computer Setup
To do this
●
Set a Startup Menu delay (in seconds).
●
Enable/disable Custom Logo (disabled by default).
●
Enable/disable Display Diagnostic URL (enabled by
default).
●
Enable/disable CD-ROM boot (enabled by default).
●
Enable/disable SD Card boot (enabled by default).
● Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (disabled by
default).
●
Set the Express Boot Popup delay in seconds.
● Set the boot order.
●
Enable/disable USB legacy support (enabled by
default). When enabled, USB legacy support allows the
following:
◦ Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not
running.
◦ Startup from bootable USB devices, including a
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
●
Enable/disable fan always on while connected to an AC
outlet (disabled by default).
●
Enable/disable Data Execution Prevention (select
models only; disabled by default). When enabled, the
processor can disable some virus code execution,
which helps to improve computer security.
●
SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
NOTE: Availability of the options above varies by
computer model.
● Enable/disable HP QuickLook 2 (enabled by default).
●
Enable/disable Virtualization Technology (select models
only; disabled by default).
●
Enable/disable Dual-Core CPU (enabled by default).
● Enable/Disable Unified Extensible Firmware Interface
(UEFI) mode (enabled by default).