Dell PowerConnect W-IAP3WN Installation Manual page 2

Product Specifications
Electrical
Ethernet:

3 x 10/100Base-T auto-sensing Ethernet RJ-45 Interfaces

MDI/MDX

IEEE 802.3 (10Base-T), IEEE 802.3u (100Base-T).

Power - W-IAP3WNP:

48VDC power interface, supports powering through an AC-to-DC power

adapter
Power -W-IAP3WN:

12 VDC power interface, supports powering through an AC-to-DC power

adapter
Note: If a power adapter other than the one provided by Aruba Networks is used
in the US or Canada, it should be NRTL Listed, with appropriate voltage and
current rating, marked "LPS" or "Class 2," and suitable for plugging into a
standard power receptacle in the US and Canada.
For additional specifications on this product, please refer to the data sheet. The data
sheet can be found at dell.com/wireless.
Proper Disposal of Dell Equipment
For the most current information about Global Environmental Compliance and Dell
products, see our website at dell.com.
Waste of Electrical and Electronic Equipment
Dell products at end of life are subject to separate collection and
treatment in the EU Member States, Norway, and Switzerland and
therefore are marked with the symbol shown at the left (crossed-
out wheelie bin). The treatment applied at end of life of these
products in these countries shall comply with the applicable
national laws of countries implementing Directive 2002/96EC on
Waste of Electrical and Electronic Equipment (WEEE).
European Union RoHS
Dell products also comply with the EU Restriction of
Hazardous Substances Directive 2002/95/EC (RoHS). EU
RoHS restricts the use of specific hazardous materials in the
manufacture of electrical and electronic equipment. Specifically, restricted materials
under the RoHS Directive are Lead (including Solder used in printed circuit
assemblies), Cadmium, Mercury, Hexavalent Chromium, and Bromine. Some Dell
products are subject to the exemptions listed in RoHS Directive Annex 7 (Lead in
solder used in printed circuit assemblies). Products and packaging will be marked
with the "RoHS" label shown at the left indicating conformance to this Directive.
China RoHS
Dell products also comply with China environmental declaration
requirements and are labeled with the "EFUP 10" label shown at the
left.
Hazardous Materials Declaration
(Hazardous Substance)
(Parts)
PCA Boards)
Mechanical Sub-Assemblies)
SJ/T11363-2006
Indicates that the concentration of the hazardous substance in all homogeneous materials in the parts is
below the relevant threshold of the SJ/T11363-2006 standard.
Indicates that the concentration of the hazardous substance of at least one of all homogeneous materials
in the parts is above the relevant threshold of the SJ/T11363-2006 standard.
This table shows where these substances may be found in the supply chain of electronic information
products, as of the date of sale of the enclosed product.
The Environment- Friendly Use Period (EFUP) for all enclosed products and their parts are
per the symbol shown here. The Environment- Friendly Use Period is valid only when the
product is operated under the conditions defined in the product manual.
Safety and Regulatory Compliance
Dell provides a multi-language document that contains country-specific restrictions
and additional safety and regulatory information for all Dell hardware products. The
Dell PowerConnect W-Series Safety, Environmental, and Regulatory Information
document is included with this product.
Caution: Installation and service of Dell PowerConnect W-Series products
should be performed by trained service personnel only.
Caution: RF Radiation Exposure Statement: This equipment complies with FCC RF
radiation exposure limits. This equipment should be installed and operated with a
minimum distance of 7.87 inches (20cm) between the radiator and your body for
2.4 GHz operations. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
EMC Compliance and Warning Statement
FCC
The device is electronically labeled and the FCC ID will be displayed via the WebUI
under the About menu.
This device complies with Part 15 of the Federal Communications Commission
(FCC) Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.

This device must accept any interference received, including interference that

may cause undesired operation.
Caution: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
The device has been found to be compliant to the requirements set forth in CFR 47
Sections 2.1091 for an uncontrolled environment. The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance
with the manufacturer's instructions, may cause interference harmful to radio
communications.
If this equipment does cause interference, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.
Consult the dealer or an experienced radio or TV technician for help.

Complies with the Class B limits for radio noise emissions as set out in the
interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of
Industry Canada.
Cet apareil numerique de la classe B respecte toutes les exigencies du Reglement sur
le materiel brouilleur du Canada.
L ' utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il
ne doit pas produire de brouillage et (2) l' utilisateur du dispositif doit étre prêt à
accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif.
Le présent appareil est conforme aux normes CNR d'industrie Canada applicables
aux appareils radio exempts licence. L'exploitation est autorisée aux deux conditions
suivantes:
1. L'appareil ne doit produire de brouillage, et
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
EU Regulatory Conformance
This product is CE marked according to the provisions of the R & TTE
Directive (99/5/EC) - CE(!). Aruba Networks Inc., hereby declares that this
W-IAP3WN/P device models are in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. CE(!)
The Declaration of Conformity made under Directive 1999/5/EC is available for
viewing at the following location in the EU community.
Dell PowerConnect W-IAP3WN/P
Instant Access Point
Installation Guide
Contacting Support
Web Site Support
Main Site dell.com
Support Site support.dell.com
Dell Documentation support.dell.com/manuals
Copyright
© 2012 Aruba Networks, Inc. Aruba Networks trademarks include , Aruba Networks
®
Aruba Wireless Networks , the registered Aruba the Mobile Edge Company logo, and Aruba Mobility
®
Management System . Dell™, the DELL™ logo, and PowerConnect™ are trademarks of Dell Inc.
All rights reserved. Specifications in this manual are subject to change without notice.
Originated in the USA. All other trademarks are the property of their respective owners.
Open Source Code
Certain Aruba products include Open Source software code developed by third parties, including software code
subject to the GNU General Public License (GPL), GNU Lesser General Public License (LGPL), or other Open
Source Licenses. The Open Source code used can be found at this site:
http://www.arubanetworks.com/open_source
Legal Notice
The use of Aruba Networks, Inc. switching platforms and software, by all individuals or corporations, to terminate
other vendors' VPN client devices constitutes complete acceptance of liability by that individual or corporation for
this action and indemnifies, in full, Aruba Networks, Inc. from any and all legal actions that might be taken against
it with respect to infringement of copyright on behalf of those vendors.
www.dell.com
Dell PowerConnect W-IAP3WN/P Instant Access Point | Installation Guide
Part Number 0511153-01 | September 2012
®
,