Child Lock; Input Label; Fine Sync - Sharp AQUOS LC-32GD8E Operation Manual

Menu operations

Child Lock

Allow you to use a PIN to protect certain settings from
being accidentally changed.
Changing the PIN
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Child Lock", and then press
OK.
Change PIN
Reset
4
Enter the 4-digit number as a PIN using 0 – 9.
5
Enter the same 4-digit number as in step 4 to
confirm.
• "The system PIN has been changed successfully"
displays.
NOTE
• To view a locked channel, you must enter a PIN. (See
pages 16 and 27 for locking channels from viewing in
analogue TV and DTV mode.) When you select a locked
channel, a PIN prompt message pops up. Press OK to
display the PIN input window.
Resetting the PIN
Allow you to reset your PIN to the factory preset "1234".
1
Repeat steps 1 to 3 in Changing the PIN.
2
Enter the PIN.
3
Press a/b to select "Reset", and then press OK.
4
Press c/d to select "Yes", and then press OK.
NOTE
• As a precautionary measure, make a note of your PIN
on the back of this operation manual, cut it out and
keep it in a safe place that children cannot reach.
• See page 32 for resetting the current PIN to the factory
preset "1234" if you lose or forget your PIN.
TV only
New PIN – – – –
Reconfirm – – – –

Input Label

You can assign each input source a label you like.
1
Press b to select the desired input source.
2
Press MENU and the MENU screen displays.
3
Press c/d to select "Setup".
4
Press a/b to select "Input Label", and then press
OK.
5
Press a/b/c/d to select each character of the
new name for the input source, and then press
OK.
6
Repeat step 5 above until the name is fully spelt
out, and then press OK.
• The name can be 6 characters or less.
• If a label name is less than 6 characters, select
"END", then press OK.
NOTE
• You cannot change the label if the input source is TV or
DTV.

Fine Sync.

Menu Operation: C (Page 12)
Ordinarily, the TV automatically adjusts image positions
coming from PC (Auto Sync. function). In some cases,
however, manual adjustment is needed to optimise the
image.
Item
H-Pos.: Centres the image by moving it to the left or right.
V-Pos.: Centres the image by moving it up or down.
Clock: Adjusts when the image flickers with vertical
stripes.
Phase: Adjusts when characters have low contrast or
when the image flickers.
NOTE
• If you need to adjust the image position, adjust the position
using your PC.
PC only
17