Table of Contents
Advertisement
TROUBLESHOOTING
TROUBLESHOOTING
AREA
INSTALLATION
POWER
PLAYBACK
RECORDING
PROBLEM
TV will not tune in to
the VCR.
Auto Installation
screen does not
appear when the
VCR is switched on
OR Auto Installation is
not complete.
Display is not working. Make sure the power cord is plugged in.
VCR will not operate -
appears in VCR
display.
VCR will not respond
to any commands.
No picture appears.
Playback picture is
snowy.
Playback recording
does not playback in
stereo.
Tape is automatically
ejected when
REC
pressing
(
) or
TIMER
ON/OFF
buttons.
SHOWVIEW does not
record desired
programme (VC-
MH76FPM).
POSSIBLE CAUSE/CURE
Check all the cables are correctly connected.
Check your TV manual for correct tuning of your
TV.
Reset the VCR and complete AUTO
INSTALLATION again. (Refer to VCR Reset at the
back of the book.)
Make sure the wall socket has power (plug
another appliance in).
Press the
TIMER ON/OFF
disengage timer.
Check CHILD LOCK is not engaged.
Safety device operating: unplug VCR for 2
hours.
Make sure the TV is set to the video channel.
Check all connecting cables.
Adjust the tracking using
/
buttons.
Try another tape.
The video heads may have been
contaminated - refer to a SHARP Service Facility.
Ensure the VCR is connected to a stereo TV and
SCART lead.
Programme may not carry stereo.
The record-protection tab has been removed.
Ensure date and time are correctly set on the
VCR.
GB-35
button to
CHANNEL
Advertisement
Table of Contents
