Advertisement
FIGURE 2 – MOUNTING HOLE LOCATIONS
INSTALLATION INSTRUCTIONS
Note: Toshiba's 2.5" HDDs are primarily used in notebook devices. Installation into a
notebook varies depending on the system manufacturer. Toshiba's 2.5" drives that
are installed into a desktop PC require a 3.5" installation kit.
1. Determine mounting configuration (can be mounted in either a horizontal or verti-
cal orientation).
2. Configure drive for system application.
3. Install the I/F cable to the system's 44 pin connector port or adapter board (if
required). Ensure Pin 1 is oriented correctly. (Pin 1 on the cable is usually identi-
fied by a red or blue stripe.)
4. Refer to applicable manuals for software installation instructions.
P/N 480071-A0
12/05
MOUNTING HOLES
2.5" Hard Disk Drive Installation Notes - MK1234GAX/MK6034GAX Series
Advertisement
