Advertisement

ATI Theater™ Video Remote
User Guide
Part Number: 137-71172-10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATI Theater and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AMD ATI Theater

  • Page 1 ATI Theater™ Video Remote User Guide Part Number: 137-71172-10...
  • Page 2 AMD’s product could create a situation where personal injury, death, or severe property or environmental damage may occur. AMD reserves the right to discontinue or make changes to its products at any time without notice.
  • Page 3 Install outdoor antenna system away from power lines. Warning: When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them may be fatal. © 2008 AMD ATI Theater™ Video Remote...
  • Page 4 NEC, which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as is practical. ATI Theater™ Video Remote © 2008 AMD...
  • Page 5: Table Of Contents

    Getting Started ..........1 Product Overview .
  • Page 6 ATI Theater™ Video Remote © 2008 AMD...
  • Page 7: Getting Started

    Product Overview The Theater™ Video Remote is an infrared (IR)-based remote control that supports ATI Catalyst™ Media Center software for the PC, as well as limited navigation functionality for Windows® Media Center. System Requirements Hardware Supported Operating Systems Getting Started A computer with native USB 2.0 support.
  • Page 8 Getting Started ATI Theater™ Video Remote © 2008 AMD...
  • Page 9: Installing Thetheater™ Video Remote

    Installing theTheater™ Video Remote To install the Theater™ Video Remote: Open the battery container on the back of the Theater™ Video Remote and insert two AAA batteries. Plug the remote receiver into any available USB port on your computer. The Theater™...
  • Page 10 Installing theTheater™ Video Remote ATI Theater™ Video Remote © 2008 AMD...
  • Page 11: Theater™ Video Remote Functions

    Chapter 3 Theater™ Video Remote Functions Figure 3–1 Button Diagram The following list describes the Theater™ Video Remote functions when used with ATI Catalyst Media Center (CMC) software.
  • Page 12: Button Functions

    Button Functions Number on Diagram ATI Theater™ Video Remote Function Power Channel\numeric entry buttons (1 through 0) Last channel (channel switch) Closed Captioning on/off Launch CMC/Home/Close CMC FM Radio (if using tuner hardware) Left, Up, Right, Down selection buttons OK (Select) button...
  • Page 13: Reference

    Troubleshooting Remote does not work. Replace batteries (size AAA). • The USB receiver may not be detected by your system. Try another USB port. • Remote control works sporadically. Check batteries. • Check the line of sight to the USB receiver. •...
  • Page 14: Industry Canada Compliance Statement

    Safety—Part 1: General Requirements) CSA C22.2 No. 60950-1-03, 1st edition, 2006-07 (Information Technology • Equipment—Safety—Part 1: General Requirements) To meet UL safety requirements, the computer’s maximum room temperature should not exceed 40 °C. ATI Theater™ Video Remote © 2008 AMD...
  • Page 15: Waste Electrical And Electronic Equipment (Weee) Directive Compliance

    MIC Certification Information "Class B" Equipment (Household purpose info/telecommunications equipment) As this equipment has undergone EMC registration for household purpose, this product can be used in any area including residential area. BSMI Certification Information © 2008 AMD ATI Theater™ Video Remote...
  • Page 16 Reference ATI Theater™ Video Remote © 2008 AMD...

Table of Contents

Save PDF