Editing Channels; Satellite System Setup - Samsung 6 series User Manual

Satellite System Setup

The PIN input screen appears. Enter your 4 digit PIN number.
Satellite System Setup is available when Antenna is set to
Satellite. Before running Auto Store, set Satellite System
Setup. Then channel scan is run normally.
Satellite Selection
■
this TV.
LNB Power (Off / On)
■
supply for the LNB.
LNB Settings : Configures the outdoor equipment.
■
Satellite: Selects the satellite for receiving digital
broadcasts.
Transponder: Selects a transponder from the list or
adds a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected
LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a
lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a
higher frequency.
Tone 22 khz (Off / On / Auto): Selects the Tone 22
kHz depending on the LNB type. For a universal LNB it
should be Auto.
Signal Quality: Display the current status of
broadcasting signal.
Positioner Settings
■
Positioner (Off / On): Enables or disables the positioned
control.
Positioner Type (USALS / DiSEqC 1.2): Sets
the positioned type between DiSEqC 1.2 and
USALS(Universal Satellite Automatic Location System).
– My Longitude
– My Latitude : Sets the latitude for my location.
– Satellite Longitude Settings
user defined satellites.
User Mode: Sets the position of satellite antenna
according to each satellite. If you store the current
position of satellite antenna according to a certain
satellite, when the signal of that satellite is needed,
the satellite antenna can be moved to pre-populated
position.
– Satellite : Selects the satellite to set the position for.
– Transponder:
signal reception.
– Moving Mode:
discrete and continuous movement.
BN68-02631F_Eng.indb 13
: You can choose the satellites for
: Enables or disables the power
: Configures the antenna positioner.
: Sets the longitude for my location.
: Sets the longitude of
Selects a transponder from the list for
Selects the movement mode between
– Step Size: Adjusts the step size degrees for the
antenna rotation. Step Size is available when Moving
Mode is set to Step.
– Go to Stored Position : Rotates the antenna to the
stored satellite position.
– Antenna Position : Adjusts and stores the antenna
position for the selected satellite.
– Store Current Position : Stores current position as
the selected positioner limit.
– Signal Quality : Display the current status of
broadcasting signal.
Installer Mode: Sets limits to the scope of movement
of satellite antenna or reset the position. Generally,
installation guide uses this function.
– Limit Position (East / West)
the positioner Limit.
– Antenna Position: Adjusts and stores the antenna
position for the selected satellite.
– Store Current Position:
as the selected positioner Limit.
– Go to Zero : Moves the antenna to the reference
position.
– Reset Positioner Limit : Allows the antenna to rotate
over the full arc.
Reset All Setting (OK / Cancel)
■
be reset to the initial values.

Editing channels

¦
Channel Manager Option Menu
(in Channel Manager)
1. Select a channel and press the
2. Edit the channel name or number using the Edit
Channel Name or Edit Channel Number menu.
Edit Channel Name (analogue channels only): Assign
■
your own channel name.
Edit Channel Number (digital channels only): Edit the
■
number by pressing the number buttons desired.
: Selects the direction of
Stores the current position
: All satellite settings will
TOOLS button.
13
English
2010-03-03 8:34:56