Samsung DMS400TU User Manual page 27

pROblem
Leaves an oily film on the
dishes. The dishes are
not clean enough.
Is too noisy.
Leaves glasses with a
dim polish.
Leaves black or gray
marks on the dishes.
Leaves a yellow or brown
film on the inside of the
dishwasher.
Does not have any lamps
lit.
Does not have a
smoothly rotating spray
arm.
has a bent top basket
after loading dishes.
UserManual-DMS400TU_EN.indd 27
pOSSIble CAUSe
The amount of detergent is incorrect. Supply the appropriate amount of
Too many dishes have been loaded.
Dishes are loaded incorrectly.
The pressure of the supplied water is
insufficient.
Improper detergent is being used.
There is no rinse aid.
The water is too hard.
Sound is generated when the
dispenser cover is open. Sound is
generated when the drain pump is
operating at an early stage.
The dishwasher is not level.
There is a 'chopping' sound because
a nozzle is bumping against the
dishes.
The supplied water is soft and too
much detergent is being supplied.
Aluminum dishes have been loaded.
This occurs from coffee and tea
soils.
The power is not connected.
The nozzle hole is clogged with food
particles.
The dishes are not loaded properly.
SOlUTION
automatic dishwasher detergent.
Load only an appropriate number of
dishes.
Load your dishes as recommended
(refer to the "Loading the top and
bottom baskets" section).
The proper pressure of the supplied
water is 0.05 ~ 0.8 MPa.
Use an automatic dishwasher
detergent.
Check the dispenser and add rinse
aid.
Add salt into the salt container.
This is a normal operation.
Ensure that the dishwasher is level.
Rearrange the dishes.
Underload the dishwasher and use a
rinse aid to minimize this.
Remove the marks on the dishes
using a low sensitivity cleaner.
Remove the soils using a spot
cleaner.
Connect the power cord.
Clean the nozzle hole.
Load your dishes as recommended
(refer to the "Loading the top and
bottom baskets" section).
troubleshooting _27
2010-05-10 4:44:46