Table of Contents
Advertisement
•
Latin America/Asia Pacific: 110-240V~,
50-60 Hz
•
Power consumption: 55 W
•
Standby power consumption: ≤ 0.9 W
•
Dimensions (WxHxD): 360 x 58 x 325 mm
•
Weight: 2.3 kg
Subwoofer
•
Output power: 50 W RMS (30% THD)
•
Impedance: 4 ohm
•
Speaker drivers: 133 mm (5.25") woofer
•
Dimensions (WxHxD): 160 x 265 x 265
mm
•
Weight: 2.50 kg
•
Cable length: 3 m
Speakers
Center speaker:
•
Output power: 50 W RMS (30% THD)
•
System: 1 x 63.5 mm (2.5") full range
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 63.5 mm (2.5") woofer
•
Dimensions (WxHxD): 159 x 84.5 x 80 mm
•
Weight: 0.35 kg
•
Cable length: 2 m
Front/Rear speaker:
•
Output power: 4 x 50 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 63.5 mm (2.5") full
range
•
Dimensions (WxHxD): 84.5 x159 x 80mm
•
Weight (front): 0.35 kg/each
•
Weight (rear): 0.35 kg/each
•
Cable length (front): 3 m
•
Cable length (rear): 7 m
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Type: Semiconductor laser GaAIAs (CD)
•
Wave length: 645 - 665 nm (DVD), 770 -
800 nm (CD)
•
Output power: 6 mW (DVD), 7 mW
(VCD/CD)
•
Beam divergence: 60 degrees.
9
Troubleshooting
Warning
•
Risk of electric shock. Never remove the
casing of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
Main unit
The buttons on the home theater do not work.
•
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the home theater.
•
If this happens when you change the
TV system, press
compartment, and then 3 on the remote
control to restore the default TV system..
No picture on a TV connected through HDMI.
•
Make sure that the HDMI cable is not faulty.
If it is faulty, replace it with a new cable.
•
Press
to open the disc compartment, and
then 1 on the remote control to restore the
default picture resolution.
•
Wait for 10 seconds for auto recovery, or
change the HDMI video setting (see 'Picture
resolution' on page 19).
Disc does not play high-definition video.
•
Make sure that the disc contains high-
definition video.
•
Make sure that the TV supports high-
definition video.
•
Use an HDMI cable to connect to the TV.
to open the disc
EN
23
Advertisement
Table of Contents
