Standard Horizon MST660 Owner's Manual page 12

MST660 I.M.-2 21/12/99 1:26 PM
Speaker Connections
When connecting the speakers, observe the correct polarity as shown in the
diagram. Incorrect polarity will result in a reduction of Bass response and stereo
effect. The use of speakers with an impedance of less that 4 Ohms is not
recommended, as they will cause excessive loading of the MST660's output
circuit.
Caution: The MST660 is a four speaker system that requires 2 separate wires
for each speaker.
• DO NOT connect the negative (-ve) terminals of the speaker wires
together or ground them to any part of the negative electrical Bus.
• DO NOT short the +ve and –ve speaker wires together.
Damage caused by the above will not be covered under warranty.
Left
Front
Left
Rear
Connect all four speakers as shown in the diagram. Adjust the Fader control
for the required front/rear balance. If you wish to connect only two speakers,
connect these to the Rear speaker wires. The remaining speaker wires should
be insulated to ensure they cannot short circuit together or to ground. If using
only two speakers, adjust the Fader control to the Rear speakers.
Page 10
Page 12
+
+
–
–
+
+
– –
MST660
Owner's Manual
Right
Front
Right
Rear
MST660