Electrical Requirements - Daewoo DWF-200M Instruction Manual

DWF-200/240M(101) 97.1.19 4:21 PM ˘ ` 5
1
In case that it goes over
a door sill.
Don't let the height of
the drain hose exceed
20cm from the bottom
of washer.
Laundry tub drain system
• Top of tub must be at least 86cm
(34inches) high and no higher than 130cm
from bottom of washer (A)

ELECTRICAL REQUIREMENTS

electrical shock hazard:failure to follow these instructions could result in
WARNING
•
Electrical earth is required on this washer
•
If it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
C
B
A
Non-Pump Model
2
In case of extending the
drain hose.
Don't let the total length
exceed 3m.
20Cm
Pump Model
A
death or serious injury.
Recommended earthing method
For your personal safety, this washer must be earthed.
This washer is equipped with a power supply cord (A) having a
earthing plug (B). To minimize possible shock hazard, the cord must
be plugged into a mating earthing-type wall receptacle (C).
If a mating wall receptacle is not available, it is the personal
responsibility and obligation of the customer to have the proper
earthed wall receptacle installed by a qualified electrician.
3
Be careful that the end
of the drain hose is not
immersed in water.
3m
Standpipe drain system
•
Needs a 3cm minimum diameter
standpipe with minimum carry away
capacity of 30liters per minute.
• Top of tub must be at least 86cm
(34inches) high and no higher than 130cm
from bottom of washer (B)
B
•
Don't earth to a gas pipe
•
Don't change the power supply cord plug.
•
Check with a qualified electrician if you are not
sure the washer is properly earthed.
5