Table of Contents
Advertisement
DWF-201M 97.1.19 4:23 PM ˘ ` 6
INLET HOSE CONNECTION
Be careful not to confuse hot water inlet and cold water inlet.
In using only one water tap or in case of attached one water inlet valve, connect the
inlet hose to the cold water inlet valve.
For Ordinary Tap
1 Pull down the collar of
the inlet hose to separate
it from the water tap
adapter.
4 Remove the tape, and
screw connector B into
connect A tightly.
Connector A
Connector B
For Screw-Shaped Tap
1 Connect the inlet hose to
the water tap by
screwing the connector
.
tightly.
Rubber
Connector
Packing
Hose
Connector
2 Loosen the four screws
properly in fitting into
water tap.
5 Connect the inlet hose to
the water tap adapter by
pulling down the collar of
the hose end.
2 Connect the connector-
inlet supplied if
necessary.
Connector
inlet
Rubber
Connector
Packing
Hose
Connector
6
3 Fit the water tap adapter
into the water tap
and tighten the four
screws evenly while
pushing up the adapter
so that the rubber
packing can attach to the
water tap tightly.
TAPE
6 Connect the inlet hose
adapter of the hose to
the water inlet of the
washer by turning it
clockwise to be fixed
tightly.
•
Please check the rubber
packing inside the inlet hose
adapter of the hose.
3 Insert the inlet hose
adapter into the water
inlet of a washer and turn
it to be fixed.
*Cheek the packing in the inlet
Advertisement
Table of Contents
