1. Installation Instructions
Suitable Installation Place
Where the floor is solid and level
Where ventilation is good
•
Unstable installation causes vibration and
•
More than 6 or 10 cm from 3 sides (left,
noise of refrigerator.
right and back) is good enough for
ventilation.
•
Wooden floor or carpet can be discolored
under the refrigerator.
•
Insufficient space causes the noise of
vibration, weakening of refrigerating
•
Doors look hanged down due to the twist
power and the waste of electricity.
of refrigerator unless it is leveled.
Grounding
Grounding terminal is the yellow/green one connected to the power cord in the back of refrigerator.
Grounding is necessary
water can splash easily ;
where
bathroom etc.
Grounding by using
Bury copper plate to whitch grounding wire is connected 25 cm deep in the ground.
grounding wire
Grounding by using
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
short-circuit breaker
restaurant kitchen etc.
Grounding is not necessary
in case of using side-grounded outlet.
You should not connect the
water pipe, gas pipe, telephone line,
ground wire to
lightening-rod.
There can be explosion or fire.
Correct usage of Refrigerator
Plug in the refrigerator right
* See page
after installation.
Set the fresh food compartment'
* When the surrounding temperature is hot in midsummer, do not open and shut the
temperature to "7" to perform
doors too often after installation.
preparatory run for 2 or 3 hours.
When the inside is cold enough,
put the foods in.
Where there is little or no heat, moisture
•
Direct sun lays, side heat of stove and gas
range can weaken the refrigerating power.
•
Avoid location by a sink or where moisture
and water can cause rust and corrosion.
•
Avoid location where moisture can cause
electrical problems.
•
Use hard board or plank on the
concrete/cement floor.
there is much moisture ;
any wet and/or watery
basement etc.
places.
Side
Grounded
outlet
for details.
2
1
Grounding wire
Need help?
Do you have a question about the SR-5420 and is the answer not in the manual?
Questions and answers