Table of Contents
Advertisement
Open both the appliance door and
that of the kitchen unit to approx.
90¡. Place the little plates over the
runners. Hold the doors of the
appliance and the unit together
and mark the holes.
Remove the little plates and make
the holes with a diam. of 2 mm.
Replace the little platee over the
runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen
unit door, if necessary, use the
clearance size of the slotted holes.
At the end of the procedure, check
that the doors of the appliance and
the kitchen unit open properly.
If the appliance is fixed to the side
of the kitchen unit, simply slacken
the screws in the fixing brackets
(D), move the brackets as shown
in the figure and re-tighten the
screws. Then fit cover (E).
24
8mm
PR34
PR35
D734
D
E
Hide quick links:
Advertisement
Table of Contents
