Table of Contents
Advertisement
13-1278.fm Page 7 Wednesday, July 14, 1999 4:24 PM
PREPARATION
Important: Complete all other con-
nections to the System 731 before
you connect it to power.
CONNECTING THE
SPEAKERS
1. Press open the pair of terminal
tabs marked
R/SPEAKER + / –
the back of the main System
731,
then
speaker's red wire into the red
(+) terminal and its black wire
into the black (–) terminal. Then
release the tabs.
Caution: To avoid damaging
your
system
never let the speaker wire's bare
ends touch each other.
2. Repeat Step 1 to connect the left
speaker's wires to the pair of ter-
minals marked
Speaker Placement
For the best stereo effect, place the
speakers so the distance between
them is the same as the distance be-
tween the listening area and the point
halfway between the speakers. You
on
insert
the
right
and
speakers,
L/SPEAKER + / –
.
might want to experiment with sever-
al locations to find the best one.
Notes:
• If the you place the speakers far
apart, you can improve the ste-
reo effect by angling the speak-
ers toward you.
• To increase the bass sound,
place the speakers in the corner
of the room, against the wall or
directly on the floor.
• To decrease the bass sound,
move the speakers slightly away
from the corner, increase the
distance between them, and/or
raise them 6 to 8 inches off the
floor. You can purchase speaker
stands at your local Radio
Shack store.
CONNECTING THE FM
ANTENNA
To connect the supplied FM antenna,
loosen the screw caps marked
/
on the back of the
ANTENNA
300
System 731, slip the antenna's
spade lugs onto the terminals, then
tighten the screw caps.
FM
7
Advertisement
Table of Contents
