Advertisement
12-1734.fm Page 2 Monday, July 12, 1999 9:48 AM
Two-Speaker System
Four-Speaker System
If your auto sound system has a front-to-
rear fader, connect your speakers as fol-
lows.
MOUNTING THE
SPEAKERS
1. Select a flat area (such as your car's
rear deck) for the mounting surface.
The
surface
should
enough to support the weight of the
speakers.
2. Using the supplied template, cut two
speaker holes.
3. Drill three
/
-inch holes for each
5
32
speaker's mounting screws, and
another for each speaker's wire.
4. Route the speaker wire from your
auto sound system, through the
mounting surface to the speaker
location, and connect it to the
speaker (see "Wiring the Speakers").
Caution:
Avoid areas where the
wires will be pinched or stepped on.
5. Cover each drilled hole with one of
the supplied nut plates.
6. Remove
the
speaker to expose the mounting
holes.
7. Insert each speaker into its mounting
location, then align each speaker's
mounting holes with the drilled holes.
8. Thread one of the supplied screws
through each hole and tighten it.
9. Firmly press the cover onto each
speaker.
2
.
be
sturdy
cover
from
each
Advertisement
